The double trade-off between adaptation and mitigation for sea level rise: an application of FUND

This paper studies the effects of adaptation and mitigation on the impacts of sea level rise. Without adaptation, the impact of sea level rise would be substantial, almost wiping out entire countries by 2100, although the globally aggregate effect is much smaller. Adaptation would reduce potential impacts by a factor 10–100. Adaptation would come at a minor cost compared to the damage avoided. As adaptation depends on socio-economic status, the rank order of most vulnerable countries is different than the rank order of most exposed countries. Because the momentum of sea level rise is so large, mitigation can reduce impacts only to a limited extent. Stabilising carbon dioxide concentrations at 550 ppm would cut impacts in 2100 by about 10%. However, the costs of emission reduction lower the avoided impacts by up to 25% (average 10%). This is partly due to the reduced availability of resources for adaptation, and partly due to the increased sensitivity to wetland loss by adaptation.

Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

The response of a mid- and high latitude peat bog to predicted climate change: methane production in a 12-month peat incubation

There are fears that global warming will lead to degradation of peatlands, higher emissions of greenhouse gases from peat, and accelerated warming. Anaerobic decomposition of organic soils produces methane (CH₄), a potent greenhouse gas. Two peat bogs differing in mean annual temperature, Velke Darko (VD, Czech Republic, 7.2 °C), and Stor Åmyran (SA, Sweden, 4.0 °C), were selected for a comparative study of how organic soils in different climatic zones will respond to warmer and drier conditions. Twenty peat cores from each bog were incubated in growth chambers. Under present-day summer conditions, VD produced 14 times more CH₄ than SA. Two different warming scenarios were used. Peat-core replicates were kept at temperatures of 11 versus 16 °C, and 11 versus 22 °C. From 11 to 16 °C, the CH₄ production slightly decreased at SA, and slightly increased at VD. From 11 to 22 °C, the CH₄ production increased 9 times at SA, but slightly decreased at VD. After an 8-month incubation, peat cores under drying conditions (water table at ?14 cm) were compared to samples with original water table (?2 cm). Drying conditions led to a steeper reduction in CH₄ production at VD, compared to SA. The CH₄ production decreased more than 100 times at VD. Then, the combined effect of simultaneous warming and drying at 11 and 22 °C was studied. We did not find any significant effect of interactions between increasing temperature and decreasing water table level. Overall, the warmer site VD responded more strongly to the simulated climate change than the colder site SA.     

A Novel Method to Capture and Analyze Flow in a Gross Pollutant Trap Using Image-Based Vector Visualization

A novel method is developed to capture and analyze several experimental flow regimes through a gross pollutant trap (GPT) with fully and partially blocked screens. Typical flow conditions and screen blockages are based on findings from field investigations that show a high content of organic matter in urban areas. Fluid motion of neutral buoyant particles is tracked using a high-speed camera and particle image velocimetry (PIV) software. The recorded fluid motion is visualized through an image-based, line integral convolution (LIC) algorithm, generally suitable for large computational fluid dynamics (CFD) datasets. The LIC method, a dense representation of streamlines, is found to be superior to the point-based flow visualization (e.g., hedgehog or arrow plots) in highlighting main flow features that are important for understanding litter capture and retention in the GPT. Detailed comparisons are made between the flow regimes, and the results are compared with CFD data previously obtained for fully blocked screens. The LIC technique is a useful tool for identifying flow structures in the GPT and areas that are subjected to abnormalities difficult to detect by conventional methods. The novel method is found to be useful both in the laboratory and in the field, with little preparation and cost. The enhancements and pitfalls of the LIC technique along with the experimentally captured flow field are presented and discussed.     

Ionic composition of TSP and PM2.5 during dust storms and air pollution episodes at Xi'an,China

TSP and PM_2.5 samples were collected at Xi'an, China during dust storms (DSs) and several types of pollution events, including haze, biomass burning, and firework displays. Aerosol mass concentrations were up to 2 times higher during the particulate matter (PM) events than on normal days (NDs), and all types of PM led to decreased visibility. Water-soluble ions (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, F^?, Cl^?, NO₃^?, and SO₄^2?). were major aerosol components during the pollution episodes, but their concentrations were lower during DSs. NH₄⁺, K⁺, F^?, Cl^?, NO₃^?, and SO₄^2? were more abundant in PM_2.5 than TSP but the opposite was true for Mg²⁺ and Ca²⁺. PM collected on hazy days was enriched with secondary species (NH₄⁺, NO₃^?, and SO₄²) while PM from straw combustion showed high K⁺ and Cl^?. Firework displays caused increases in K⁺ and also enrichments of NO₃^? relative to SO₄^2?. During DSs, the concentrations of secondary aerosol components were low, but Ca²⁺ was abundant. Ion balance calculations indicate that PM from haze and straw combustion was acidic while the DSs samples were alkaline and the fireworks' PM was close to neutral. Ion ratios (SO₄^2?/K⁺, NO₃^?/SO₄^2?, and Cl^?/K⁺) proved effective as indicators for different pollution episodes.     

Assessment of total urban metabolism and metabolic inefficiency in an Irish city-region

This paper aims to measure product and waste flows in an Irish city-region using the principles of metabolism and mass balance. An empirical indicator to measure resource efficiency, using a ratio of waste disposal as a function of product consumption, was developed and it was found that total materials metabolic inefficiency fell by 31% from 0.13 in 1996 to 0.09 in 2002. The paper concludes by analyzing the strengths and weaknesses of this indicator and its potential application in the field of sustainable consumption and resource efficiency as well as making suggestions to improve and strengthen the indicator.     

Seasonal and diurnal measurements of carbon monoxide and nonmethane hydrocarbons at Mt. Wilson,California: Indirect evidence of atomic Cl in the Los Angeles basin

We present a study of the seasonal and diurnal variability of carbon monoxide and selected volatile organic compounds in the Los Angeles area. Measurements were made during four different nine-day field campaigns in April/May, September, and November, 2007, and February, 2008, at the Mt. Wilson sampling site, which is located at an elevation of approximately 1700 m in the San Gabriel Mountains overlooking Pasadena and the Los Angeles basin. The results were used to characterize the Mt. Wilson site as a representative location for monitoring integrated Los Angeles basin emissions, and, by reference to carbon monoxide emissions, to estimate average annual emissions. The considerable seasonal variability of many hydrocarbons, in both their measured mixing ratios and their relationship to carbon monoxide, was indicative of variable source strengths. Most interestingly, perturbation of C₄ hydrocarbon ratios suggested an enhanced role for chlorine chemistry during the month of September, likely as the result of Los Angeles’ coastal location. Such coastal influence was confirmed by observations of enhanced mixing ratios of marine halocarbons, as well as air mass back trajectories.     

Interlaboratory evaluation of trace element determination in workplace air filter samples by inductively coupled plasma mass spectrometry

Inductively coupled plasma mass spectrometry (ICP-MS) is becoming more widely used for trace elemental analysis in the occupational hygiene field, and consequently new ICP-MS international standard procedures have been promulgated by ASTM International and ISO. However, there is a dearth of interlaboratory performance data for this analytical methodology. In an effort to fill this data void, an interlaboratory evaluation of ICP-MS for determining trace elements in workplace air samples was conducted, towards fulfillment of method validation requirements for international voluntary consensus standard test methods. The study was performed in accordance with applicable statistical procedures for investigating interlaboratory precision. The evaluation was carried out using certified 37-mm diameter mixed-cellulose ester (MCE) filters that were fortified with 21 elements of concern in occupational hygiene. Elements were spiked at levels ranging from 0.025 to 10 μg filter(-1), with three different filter loadings denoted "Low", "Medium" and "High". Participating laboratories were recruited from a pool of over fifty invitees; ultimately twenty laboratories from Europe, North America and Asia submitted results. Triplicates of each certified filter with elemental contents at three different levels, plus media blanks spiked with reagent, were conveyed to each volunteer laboratory. Each participant was also provided a copy of the test method which each participant was asked to follow; spiking levels were unknown to the participants. The laboratories were requested to prepare the filters by one of three sample preparation procedures, i.e., hotplate digestion, microwave digestion or hot block extraction, which were described in the test method. Participants were then asked to analyze aliquots of the prepared samples by ICP-MS, and to report their data in units of μg filter(-1). Most interlaboratory precision estimates were acceptable for medium- and high-level spikes (RSD <25%), but generally yielded greater uncertainties than were anticipated at the outset of the study.